make changes with out losing current cases
Thanks in advance for your help. Each time that I deploy an application everything works fine, but if i need to make a change in one form (for example to add a new field) and I execute again the process, all cases that was on execution resets and every cases that was on execution and ended cases disappear . Exists a way to make changes without reset all current cases that are executing and all ended cases?
Hello Boso2013,
I am facing the same problem and was glad to see your solution. However, I am not sure what do you technically mean by incrementing the version of the process. Do you mean like copy the logic, paste it in a new digramm and just name it the same with incrementing the version ?
I would be very thankful for your Answer, Cheers!
Comments
hi,
the way to do this is from the Studio menu, Diagram -> Duplicate, and then increment the diagram and pool numbers by 1 or 0.1 depending on your numbering scheme...
I use
1.0, 2.0, 3.0 for major (logic changes) and within each
x.1, x.2, x.3 and so on, for minor cosmetic changes.
Keeps everything in check...
Good idea is to consider what your change management scenarios are to be. Bonita's agility is good but, your good change management practices will make it easier in the long run.
regards Seán
Comments
Thanks a lot for your help!!